AIR DISTRIBUTION KNOB (D)
AIR SEPARATION KNOB (E)
BACK STOP (F)
FOLD PLATES
Depending on the length of the sheet, the air distribution knob (D) should be rotated to supply
the air to the correct ports as follows -
Position 1 - This is for short sheets A5 or 8" long with only port 1 open
Position 2 - This is for sheets A4 or 11" long with the front port and port 2 open
Position 3 - This is for the longest sheets A3 or 17" with the front port and port 3 open.
Position0-Inthis position, only port 2 is open and can be used on long sheets
with the curl up where you need to blow air into the centre of the stack.
These setting positions are only a guide and some experimentation may obtain a better result
with non-standard settings.
This knob controls the amount of air that is fed to the paper. The machine would normally run
with this knob set at the 'High' position. If the machine is run with less than approximately 20
sheets on the loading table, or running the job to the last sheet, this knob should be set to the
low position.
This is placed up to the end of the paper stack and clamped to the moving side lay (G).
Fit the fold plates into their respective positions (long fold plate upper and short plate lower), by
locating the front pins (I) into the long slots and carefully sliding forwards (without twisting)
until the rear pins can be located into the short slots. When fully in position, pull down the fold
plate to lock into position.
Set the fold length by releasing the lock knob (H) and rotating the dial (J). The fold length may
be read on a manual plate directly off the scale (K) or for the digital fold plate by pressing the
'ON' button (L). More precise movements will be registered by pressing 'micro' button M which
will display increments (of one tenth of a millimetre, or for imperial machines one hundredth of
an inch). To preserve battery life, the display will switch off after 30 seconds.
If the fold needs to be tilted, this can be achieved by releasing knob (N) and turning the dial (J),
( ). Moving the dial to the + direction will increase the fold length
on the operator side.
(Note) Position 1 feeds most paper stocks and sizes, thus the air distribution knob can be
left in this position for most jobs.
Do not release lock knob (H)
Fitting
Settings
Fold plate Tilt
Page 10
PAPER
(74 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern