Morgana Square fold 104 Bedienungsanleitung PDF herunterladen (Seite 18)

FOLDING CARD

PAPER JAMS

For best results, the card material should always be printed cross grain as this causes less

resistance when folding. Pre scoring of card stock is also recommended

By using the plug in perforator unit to deliver card, the problem of the stock curling will be

minimised. Set the backstop and side guide to suit the work. It is recommended that when

folding card, the machine is set to batch after twenty sheets, which will allow easy off loading.

For longer runs a optional rear delivery belt stacker (Assy. No. 9-09-01) is recommended to be

used.

In the event of a paper jam, the sensor will cut out the main switch. The main fold rollers are

linked to a clutch, which will prevent sheets continuing to feed.

If for some reason a piece of paper jams in the machine, remove and check inside the fold

plates. If there is paper jammed around the fold rollers take hold of a roller and wind them by

hand to remove the jam. If it is impossible to wind the roller by hand, remove the roller

assembly as described below. After clearing a paper jam, always check inside the fold plate

(see Fold Plate Section) to make sure no torn pieces of paper are jammed inside the plate.

ROLLER ASSEMBLY - REMOVAL

The complete roller assembly unit can be removed from the machine simply by unscrewing the

knobs (Y) on each side and taking hold of the rear roller and lifting out the unit. This is

beneficial to clear paper jams, and to clean the roller for maintenance.

With the roller assembly removed, the safety circuit prevents the machine from running. Clean

the rollers with a stiff brush between the grooves using the QD wash supplied with the

machine. Replace the roller unit in the reverse sequence.

Page 18

PAPER

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 26 27

Keine Kommentare

Morgana Square fold 104 Bedienungsanleitung Seite 18